Hatsan Air Max Barrel band

Description

These are barrel bands for the Hatsan Air Max stock configuration
3d printed in carbon fiber reinforced polycarbonate material 100% fill and solid
includes barrel band and m3 Allen head screw and nut to affix.
This is intended to correct barrel droop that can happen and keeps the barrel equal height off-air cylinder and helps raise the point of impact on your scope if you run out of elevation due to it drooping too low and just want something more stable than a free-floating barrel I recommend using a barrel band of some sort if not this one I designed.
Instructions: From split gently open and slide to the desired position over the barrel and air cylinder slide to where you would like to mount
Insert the m3 screw and tighten it down to snug (the nut is affixed to aid in installation) just until the screw reaches the end of the nut do not over tighten.  I do recommend taking time as to not scratch the barrel shroud highly unlikely but in the event, I can't be held responsible.
These are very durable but will break if you stretch beyond the limits of material I have tested and they can take quite a bit of abuse once mounted it corrects barrel drops that do show up on these air rifle barrels.
The Air rifle pictured is not included and only for demonstration of the product, you will receive the barrel band and m3 mounting hardware only.
all items are individually made and checked before the shipment item is sanitized.
due to it being 3d printed although very high-quality prints there are very small lines very rare some bumps that are normal.