Crosman 1377 1322 Scope Rail Mount Weaver Picatinny 20mm PLA+ 3.75” 9 Slot USA

Description

Crosman 1377 1322 Scope Rail Mount Weaver Picatinny 20mm PLA+ 3.75” 9 Slot Made in USA
Crosman air pistol NOT included.
Easy install Scope Rail Mount for the Crosman 1377 and 1322 air pistol with Steel or Plastic Breech.
Top rail for a Scope or Dot sight. You can still use the original iron sights with this installed. The design of the rail does not interfere with the breech at all. Some rails make loading harder. Not this one. The rail is not Mil-Spec but we have tested it with lots of different rings, sights and scopes.  All worked fine. We do offer free returns if you find it will not work with your accessory.
The install is easy: Tap out the roll pin on the pump handle. Remove the Front Sight.  Slide the mount on over the barrel. Reinstall the front sight and drive the roll pin back in. You are Good to Go.
Our Mounts are printed on top of the line 3D printers. We use PLA+ which is very strong Thermoplastic. 10 Times stronger than standard PLA.  Printed in Black PLA+. Made in the USA Get Yours Now!
Crosman air pistol and accessories NOT included.
We only supply the rail.
These fit tight enough that once it is on and the barrel band is reinstalled it does not move. The fact that it fits completely around the barrel and wraps halfway around the pump tube really makes it stable.  I have tested these with several newer and older 1377s and 1322s and it has been rock solid on all. Using both Red Dots and Long eye scopes. Make sure your pistol is clean and oil free on the outside before install. That said if you want some extra piece of mind there are 2 holes rail already tapped for #10 x 24 3/16 long set screws. But I have never needed them.